Stopped in here after spending hours on the internet trying to find specialty parts for my harley air ride. Harley didn't have the tiny part in stock and it was almost $50! Browns was able to help get me back on the road an completely rebuild my air ride system for under $20 including new valves, hose, regulator etc. Thanks guys and gal read more

I brought a hydraulic cylinder in to have it repaired because oil was leaking all over and I was quoted around $200 but unfortunately when I went to pick up the cylinder it was $295 Which I was disappointed but I thought I would live with it So I came back home and installed it and it started leaking so I called up browns northside and they told me the shaft must've been pitted I said no it looks fine there is no pits so he instructed me that I could bring it back in after I was through using machinery so after I was done I uninstalled the Cylinder again and brought it back into them and after a few days later they told me the shaft was bent I asked Shouldn't that of been checked, they replied the shaft was so slight that it wasn't noticeable my thoughts were how long would it have taken to put a straight edge on it. So I asked if they were willing to work with me on installing a new shaft and since I've already paid for the labor once And they told me they would and so I asked how much would a new chrome shaft cost, they replied around $60 I said that sounds great so my reply I said go ahead and do it. Well when I went in to pick it up they wanted $255 so like a good little lad I sucked it up and paid for it, keep in mind bobcat of Spokane Has a brand new cylinder for $666 and I paid out $550 but unfortunately the bushings on the ends of the cylinder that I have are bad, so I would been better off going to Bobcat of Spokane for a brand new one or finding one cheaper especially if I would've known that the shaft was bent to begin with this is my two cents read more