Cancel

    Open app

    Search

    Meadows Petroleum Products

    3.6 (5 reviews)
    Closed Closed

    Services - Meadows Petroleum Products

    Meadows Petroleum Products Photos

    Nearby Special Offers

    Sponsored

    New on Yelp
    Heating & Air Conditioning/HVAC
    3.0
    (8 reviews)
    Heating & Air Conditioning/HVAC
    Responds in about 10 mins
    New on Yelp
    Water Heater Installation/Repair
    Loading...Loading...Loading...

    You might also consider

    More like Meadows Petroleum Products

    Recommended Reviews - Meadows Petroleum Products

    Your trust is our priority, so businesses can't pay to alter or remove their reviews. Learn more about reviews.
    Yelp app icon
    Browse more easily on the app
    Review Feed Illustration

    7 years ago

    Helpful 0
    Thanks 0
    Love this 0
    Oh no 0

    10 years ago

    Helpful 1
    Thanks 0
    Love this 0
    Oh no 0

    10 years ago

    Helpful 1
    Thanks 0
    Love this 0
    Oh no 0

    10 years ago

    Helpful 0
    Thanks 0
    Love this 0
    Oh no 0
    Photo of D L.
    0
    22
    0

    11 years ago

    Helpful 0
    Thanks 0
    Love this 4
    Oh no 0

    You might also consider

    Verify this business for free

    People searched for Heating & Air Conditioning/HVAC 6,051 times last month within 25 miles of this business.

    Verify this business

    Edwin Stipe - New truck for our growing plumbing department arrived this week.

    Edwin Stipe

    (44 reviews)

    Very fair pricing, knowledgeable plumber. Same plumber that came to quote, did the work…read more We had some leaking copper drain/waste/vent lines connected to a cast iron pipe leading to septic. I actually wanted to do the job myself but it was pretty involved. It would have taken me about 8 hours to fix. It was done professionally in just less than 4 hours. Awesome company to work with! Will recommend highly.

    We recently had a furnace and water heater installed by Edwin Stipe and, based on this…read moreinstallation, I would never recommend them to anyone. Here's the story: Several years ago, Edwin Stipe replaced our A/C. We were happy with the install, and happy with the technicians who have been inspecting the unit as part of the service plan. This is why we chose Edwin Stipe for the furnace and water heater install. Tim Fleischood of Edwin Stipe came to our house and made recommendations for the work. It sounded reasonable, and based on past work, we went ahead with the job. One of the problems I had with the old furnace was the filter was located inside the furnace and it was always collapsing. Tim said no one installed the filter in the furnace anymore, and promised it would be on the outside in the ductwork. Installation day came. The workers were friendly and respectful of our property, donning booties to keep the floor clean as the brought equipment and tools in and out of the house. This is where the positives end. When the installation was complete, I discovered the filter was installed inside the furnace, just like Tim said it would NOT be. The workers said it would be OK and the filter would not collapse. I grudgingly said OK, and they left. When they left, they said someone would contact me for the permit inspections. The A/C was running and after a couple of hours I decided to check out the filter. I had to remove 4 or 5 sheet metal screws to access the filter (ridiculous!) and the filter was indeed collapsing. Looking at the installation, I noticed, among other things, the gas to the furnace was off. WTH? Clearly the furnace was never tested, and no one said anything about returning any time to turn on the gas or testing the furnace! There were also massive air leaks in the duct work where they had installed a transition piece for the new furnace. I contacted Tim, explained my frustration, and he said they would return. The same tech who did the installation returned (I hope he never returns again). He told me (believe it or not), it doesn't matter if there are air leaks because its in the house. What?? He had absolutely no answer as to why the gas was left off and asked if I wanted the furnace tested. Uh, yeah! The tech turned on the gas and ran the furnace for about 30 seconds. He cut a very jagged hole in the side of the ductwork, mutilated a filter because it didn't fit, and cut a piece of exhaust flue in half, straightened it out, and screwed it over the filter. I was livid! It was the worst hack job I've ever seen. I contacted Tim (yet again) and sent him a picture of what was done. He promised that someone would come out fix everything. A few days later, another installation team came out and installed a proper filter holder. They left and I thought all was good. After a month and a half, I contacted Edwin Stipe to ask if a permit was applied for, because no one had contacted me for an inspection. They said they had mailed the permit information to me and I would have to contact the township for the inspection. OK, but it would have been nice if they had told me that in the beginning! Well, today were the inspections, one for electrical, one for mechanical. The electrical inspector noted that the top of the 2 foot conduit was not supported and it should be. He said it was sloppy work and he would talk to the installer. He didn't fail it, since I said I'd support the conduit. The mechanical inspector noted that the exhaust for the water heater should have a minimum of 3 screws equally spaced at each exhaust joint. Of four joints, only one had enough screws holding it together. He gave me the option of him failing the inspection or I could add screws. I promised to add screws. As much as I would have wanted Edwin Stipe to return and complete the job to the point it could pass inspection, I really didn't want to schedule them to come out yet another time, and have to reschedule the inspection. Plus, I'm not really sure they would have done it correctly. So, zero communication, three visits to complete the installation, sloppy work, and an installation I had to complete in order to pass inspection. Would I recommend Edwin Stipe? Certainly not!

    Ambler Heating & Cooling

    Ambler Heating & Cooling

    (1 review)

    Mount Airy, Germantown

    Pretty good experience overall. Our AC is old and acting up. They sent someone out to look at it…read morefor potential AC installation. He was honest that it probably needs replacing soon but got it working for now. Did a tune up and cleaned some stuff. Cost about $150 for the service call. He wasn't trying to push a new system on me which was refreshing. When it does die I'll probably call them back for a quote on a new one.

    From the owner: Since 1985, Ambler Heating & Cooling has been revolutionizing Philadelphia's HVAC landscape through…read moreinnovative smart-home integration and energy-efficient solutions. As climate technology evolves, we're pioneering the implementation of IoT-enabled systems and predictive maintenance protocols that maximize system longevity while minimizing environmental impact. Our data-driven approach to temperature control has established new benchmarks in residential and commercial HVAC services. Our commitment to sustainability extends beyond traditional heating and cooling solutions. We're at the forefront of incorporating renewable energy systems, utilizing solar-thermal integration and geothermal technologies to create comprehensive climate control solutions. This forward-thinking approach has positioned us as Philadelphia's leading authority in eco-conscious HVAC services. Through continuous professional development and investment in cutting-edge diagnostic tools, Ambler Heating & Cooling maintains its position as an industry innovator. Our NATE-certified technicians leverage advanced analytics and real-time monitoring systems to deliver unparalleled service efficiency. This commitment to excellence, combined with our focus on energy-efficient solutions and smart technology integration, ensures we remain at the vanguard of HVAC evolution.

    Meadows Petroleum Products - hvac - Updated August 2026

    Loading...
    Loading...
    Loading...