I'm glad everyone else has had good experiences coming here, because I certainly didn't. I'm sure most of the staff might be friendly, but the guy I dealt with was one of the rudest and most condescending jerks I've ever dealt with... And I've worked retail. All I needed was a simple bend (maybe 2 bends total on each) in a section of pipe for branch resonators I was making for myself, that I was gonna install myself. This guy laughs in my face and says, "it's not that easy, I can't just bend a pipe and hope it fits, I'll have to use the lift to see how it fits". NO WAY SHERLOCK, I didn't think you were that good, otherwise you'd get 5 stars. I did the whole dual exhaust on my car by myself with simple tools and jack stands, so I know a thing or two about how to install and work with exhaust pipe. It's easy for them because they have a lift and I don't. The only reason I went here is cause I don't own a tubing bender and the dual exhaust proved difficult enough without the right tools. This guy treated me like I was an idiot. He told me I couldn't put a pipe next to a fuel tank, while pointing to my floor pan... He doesn't even know a fuel tank from a floor pan. He also didn't understand that exhaust gases weren't gonna FLOW through the pipe, only compression waves. So it isn't even gonna get hot, warm maybe... Biggest moron award. I showed him where it was gonna T-off at and he says, "you know you're gonna have to drill a hole there". YEAH! YOU DON'T SAY! Gee I would've never thought of that. I asked him what the tightest bend he could make, he responds "I can bend it all the way around", like, WHAT??? I meant what's the smallest radius you can make, you imbecile. I ended up getting him to cut two sections of pipe with a single 90° bend on each. Those instructions alone proved difficult to him. He bent the pipe first then proceeds to measure out 31" (as I wanted), of course measuring around a bend is more difficult and he's now asking me how far I want it from the bend... fml. He strikes me as a high school drop out, and working at a muffler shop is the most he'll ever achieve in life. I just took the sections home and I'll cut/weld them up myself (since I don't have a tubing bender) and install it. If you're coming here for half of what I came here for, I hope you have a better experience. read more